Sony SPP-A2470 - Manual (Page 15)

Getting Started
15 US Getting Started
Notes
• If the home area code is already entered, it appears on the display in step 3. To
enter a different home area code, see “To change the home area code” below.
• Do not allow more than 20 seconds to elapse during the operation procedure.
• If the area code has not been entered, calling back from the Caller ID list and
storing the Caller ID data into the Phone Directory cannot be performed.
Tips
• You may press Jog Dial instead of (PGM) in step 5.
• To check the current home area code, perform steps 1 to 3. The home area code
appears on the display for about 20 seconds.
To change the home area code
1
Perform steps 1 to 3 on page 14.
The current home area code appears on the display.
2
Turn Jog Dial down to erase the current home area code.
3
Enter a new home area code using the dialing keys.
4
Press (PGM).
You hear a long confirmation beep.
To erase the home area code
You can erase the home area code. Perform steps 1 and 2 above, then press
(PGM).
The home area code will be erased, and you hear a long confirmation beep.
continued
To enter the local area code (For 10 digits
phone numbers users)
If a call matches one of the local area codes you entered, the phone number
will be registered with 10 digits in the Caller ID list (area code + number).
If a call does not match one of the local area codes you entered, the phone
number will be registered with 11 digits in the Caller ID list (1 + area code
+ number). Some regions of the country allow you to have more than one
local area code. (Up to five local area codes can be entered in this phone.)
1
Press (PGM).
2
Turn Jog Dial down to make “LOCAL AREA
CODE” flash.
3
Press Jog Dial.
LOCAL AREA CODE
ONE-TOUCH A
#1 #2 #3 #4 #5