Sony SPP-A2470 - Manual (Page 64)

Additional Information 64 US
Remedy
• Make sure you follow the procedure in storing the
number correctly (pages 26 and 28).
• You entered a one-touch dialing button to which no
phone number has been stored.
• Store a correct number (pages 26 and 28).
• Press (VOLUME)(+) on the base unit to increase the
speaker volume.
• Make sure the day and time are set (page 33).
• The day and time may have been cleared due to a
power interruption. Set them again (page 33).
• Keep your message between two seconds and four
minutes.
• Make sure you speak about 12 inches (30 cm) away
from the microphone when recording.
• Check the answering mode. The phone cannot record
messages in announcement only mode (page 40).
• Make sure that the memory is not full. When the
remaining recording area is less than one minute, the
phone switches to announcement only mode
automatically.
• The phone does not record a message that is shorter
than two seconds.
• Even if the message is longer than four minutes, the
phone only records up to four minutes.
• Make sure the position of the REC. QUALITY switch
(page 39).
• Make sure you call from a touch-tone phone.
• Make sure you entered your remote ID code (security
code) within two seconds after you have entered (#).
• Make sure the remote ID code (security code) is
correct.
• Enter your remote ID code (security code) while the
greeting is being played back.
• Make sure you are calling from a touch-tone phone.
Symptom
You hear five short error beeps
and cannot store a number on a
one-touch dial or in the Phone
Directory.
You hear five short error beeps
when you try to make a one-
touch dial call.
One-touch dialing or Phone
Directory dialing is incorrect.
You cannot hear anything from
the speaker.
No time stamp is heard.
You cannot record the greeting
properly.
The phone does not record
messages
The recordable time is short.
The phone does not accept your
remote ID code (security code).
You hear error beeps when you
enter your remote ID code
(security code).
A long confirmation beep does
not sound when you enter your
remote ID code (security code).
Troubleshooting (continued)
Answering machine
Operating from an
outside phone
One-touch dialing/
Phone Directory