Sony SPP-A2470 - Manual (Page 16)

Getting Started 16 US
4
Select the number (”#1“ to ”#5“) to enter the local area code
by turning Jog Dial.
5
Press Jog Dial.
”ENTER AREA CODE“ appears on the display.
6
Enter the three digits of the local area code using the dialing
keys.
7
Press (PGM).
You hear a long confirmation beep.
Notes
• If the local area code is already entered, it appears on the display in step 4. To
enter a different local area code, see “To change the local area code” below.
• Do not allow more than 20 seconds to elapse during the operation procedure.
Tips
• You may press Jog Dial instead of (PGM) in step 7.
• To check the current local area code, perform steps 1 to 4. The local area code
appears on the display for about 20 seconds.
To change the local area code
1
Perform steps 1 to 5 on pages 15 to 16.
The current local area code appears on the display.
2
Turn Jog Dial down to erase the current local area code.
3
Enter a new local area code using the dialing keys.
4
Press (PGM).
You hear a long confirmation beep.
To erase the local area code
You can erase the local area code. Perform steps 1 and 2 above, then
press (PGM).
The local area code will be erased, and you hear a long confirmation
beep.
Step 4: Entering the area code (continued)