Sony RD-XS35SC - Manual (Page 31)

31
Introduction
Connections
Basic setup
Startup/finishing (closing) icons
These icons are displayed on the right corner on the
top of the screen. While they are flashing, the recorder
is operating as follows:
Startup, reading a disc, finishing recording
Unloading a disc, finishing the recorder’s
operation
Opening a disc tray
Closing a disc tray
Loading
Open
Un
loading
Close
If a message appears
The recorder may display a message. Each message
varies according to operational status.
To respond, follow the examples below.
Select either response (by
highlighting in green) using
/ buttons, then press
ENTER button.
The message disappears.
Read the message, then press
ENTER button.
The message disappears.
The message disappears
automatically in a few seconds.
OK
message
No OK Yes
message
Message
2 selections
No selection
message
message
OK
1 selection
Set
e.g.
e.g.
e.g.
e.g.
Turning the power off
Press ON/STANDBY button from the remote control or
on the front panel of the recorder.
The “Unloading” icon appears on the right corner of
the top of the screen, and the ON/STANDBY indicator
turns red. Then the power turns off.
Note
• If the recorder freezes for about 15 minutes and will not
respond to any buttons, holding down ON/STANDBY
button on the front panel for about 10 seconds can force
the recorder to turn off. However, this is an emergency
measure, which contains a risk of damage to data or discs.
Avoid casual use of this measure. If you try this while the
recorder is operating properly, especially while the
“Loading” or “Unloading” icon is flashing, it may result in re-
initialization of the HDD.
RD-XS35SU/SC_Inst_E_p29-43 06.2.13, 4:33 PM 31