Southbend SB1040 - Manual (Page 16)

-14-
For Machines Mfg. Since 8/09 Model SB1040/SB1041 P R E P A R A T I O N
SB1041 Circuit Requirements
Nominal Voltage ......................................... 220V
Cycle .............................................................60 Hz
Phase ....................................................... 3-Phase
Circuit Rating....................................... 15 Amps
Plug/Receptacle Type ....................... Hardwire
This machine is prewired to operate on a 220V
power supply circuit that has a verified ground
and meets the following requirements:
Grounding Requirements
In the event of certain types of malfunctions or
breakdowns, grounding provides a path of least
resistance for electric current—in order to reduce
the risk of electric shock.
Serious injury could occur if you connect
the machine to power before completing the
setup process. DO NOT connect to power until
instructed later in this manual.
Grounding Prong
Current Carrying Prongs
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
Figure 1. NEMA 5-15 plug and receptacle.
This machine is equipped with a power cord
that has an equipment-grounding wire and a
grounding plug (similar to the figure below).
The plug must only be inserted into a matching
receptacle (outlet) that is properly installed and
grounded in accordance with all local codes and
ordinances.
For 110V Connection (SB1040 Prewired)
Grounding Prong
Current Carrying Prongs
6-15 PLUG
GROUNDED
6-15 RECEPTACLE
Figure 2. NEMA 6-15 plug and receptacle.
For 220V 1-Phase Connection (SB1040)
Use the plug type listed in the Circuit
Requirements for this voltage. The listed plug
(similar to the figure below) has an equipment-
grounding wire to safely ground the machine.
The plug must only be inserted into a matching
receptacle (outlet) that is properly installed and
grounded in accordance with all local codes and
ordinances.
Power Source
LOCKING
DISCONNECT SWITCH
Machine
Conduit
Ground Ground
Conduit
Figure 3. Typical hardwire setup.
For 220V 3-Phase Connection (SB1041)
Power supply connections that are hardwired
to the power source must be connected to a
grounded metal permanent wiring system, or
to a system having an equipment-grounding
conductor.