Southbend SB1040 - Manual (Page 23)

For Machines Mfg. Since 8/09 Model SB1040/SB1041
-21-
P R E P A R A T I O N
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note: Refer to Troubleshooting on Page 44 for
solutions to common problems that occur with
all metal bandsaws. If you need additional help,
contact our Tech Support at (360) 734-1540.
To reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before beginning
any operations.
To test run your machine:
1. Read and follow the safety instructions at
the beginning of the manual, take required
safety precautions, and make sure the
machine is set up and adjusted properly
2. Clear away all tools and objects used during
assembly and preparation.
3. Make sure the blade is properly tensioned
and the blade guides are positioned correctly
(for detailed instructions, refer to Blade
Tensioning on Page 27, and Adjusting
Blade Guides on Page 30).
4. Connect the machine to the power source.
5. Push the ON button. The green motor light
will illuminate and the motor will start.
6. Verify that the machine is operating
correctly. When operating correctly, the
machine runs smoothly with little or no
vibration or rubbing noises.
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before your machine was shipped:
s Blade Guide Adjustment ..............Page 30
s V-Belt Adjustment ..........................Page 39
s Table Calibration ...........................Page 41
s Blade Tracking ................................Page 41
s Guide Post Alignment ...................Page 42
Be aware that machine components can shift
during the shipping process. Pay careful
attention to these adjustments as you test run
your machine. If you find that the adjustments
are not set according to the procedures in
this manual or they do not suit your personal
preferences, re-adjust them.
Note: For three-phase models, verify that the
blade is moving downward toward the table.
If so, the motor is running in the correct
direction. Proceed to Step 7.
s If the blade is moving in the upward
direction out of the table, stop the
machine immediately. It is likely wired
"out of phase." To correct this problem,
refer to Correcting Phase Polarity on
Page 20.
7. Adjust the blade speed through the full
range of operation. The speed should change
as you make the adjustments.
8. Press the STOP button, the green motor
light will go out, and the bandsaw will stop.
9. Turn the work lamp and the welding lamp
ON and OFF.
10. Turn the grinder ON and OFF.