Southbend SB1040 - Manual (Page 17)

For Machines Mfg. Since 8/09 Model SB1040/SB1041
-15-
P R E P A R A T I O N
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Main Inventory: (Figure 4) Qty
A. Machine .......................................................... 1
Optional Inventory: (Figure 5) Qty
B. Circle Cutting Jig ........................................... 1
C. Cap Screws M8-1.25 x 25 ............................... 2
D. Lock Washers 8mm ........................................ 2
The circle cutting jig and its mounting hardware
are not required for operation. Their installation
and use is covered in Circle Cutting Jig on
Page 36.
Figure 4. Main inventory.
A
Figure 5. Optional inventory.
B
C
D
Improper connection of the equipment-grounding
wire can result in a risk of electric shock. The
wire with green insulation (with or without
yellow stripes) is the equipment-grounding wire.
If repair or replacement of the power cord or
plug is necessary, do not connect the equipment-
grounding wire to a live (current carrying)
terminal.
Check with a qualified electrician or service
personnel if you do not understand these
grounding requirements, or if you are in doubt
about whether the tool is properly grounded.
If you ever notice that a cord or plug is
damaged or worn, disconnect it from power, and
immediately replace it with a new one.
Extension Cords
Minimum Gauge Size ............................12 AWG
Maximum Length (Shorter is Better) ....50 ft.
We do not recommend using an extension cord
with this machine. If you must use one, only
use it if absolutely necessary and only on a
temporary basis.
Extension cords cause voltage drop, which may
damage electrical components and shorten motor
life. Voltage drop increases as the extension cord
size gets longer and the gauge size gets smaller
(higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine
must contain a ground wire, match the required
plug and receptacle listed in the Circuit
Requirements for the applicable voltage, and
meet the following requirements: