Sima Products Sima SUR-35 - Manual (Page 3)

SUR-35 User Manual
Ch.
SUR-35 User Manual
Ch.
Table of Contents
Chapter 1 - Introducing the SUR-35 ................ 5
SUR-35 Features ........................................................... 5
Unpacking the SUR-35 ................................................. 6
Identifying Components ............................................... 6
Chapter 2 - Getting Started ............................... 7
Features Overview ........................................................ 7
Features (cont.) ............................................................. 8
Low Battery Indicator ................................................................... 9
Installing Batteries ........................................................ 9
Touch Screen ............................................................... 10
Turning the Touch Screen On ...................................................... 10
Touch Screen Buttons .................................................................. 11
Rubber Buttons ........................................................... 11
Menus ........................................................................... 12
Setup Menu .................................................................................. 13
Delete Menu ................................................................................. 14
Macro Menu ................................................................................. 15
Chapter 3 – Setting Up the SUR-35 ................ 16
Date and Clock ............................................................ 16
Choosing a Device ....................................................... 17
Creating a New Device ................................................................ 18
Labeling a Device ........................................................ 19
Changing the Touch Screen Layout .......................... 19
Programming Infrared Codes.................................... 22
Using Pre-programmed Manufacturer Codes .............................. 23
Using the Learning Function ........................................................ 25
Learning from Another Remote Control ...................................... 27
Page
58
Problem
You see “ERROR”
display on the LCD
during the learning
procedure.
Solution
Make sure you hold the other remote’s
button down for about 2 seconds.
Make sure you did not program more than
one remote for a given device.
Make sure the two remotes are not too
close or too far apart and are aiming
directly at each other - keep apart
between 2~4 inches (5~10cm ).
The button that you pressed has not been
taught.
You see “ERROR”
display during
operation. Teach the button using the learning
procedure. (page 31)
If unit locks up, remove one battery - wait
ten seconds - and re-install battery
Your VCR will not
record.
If your original remote requires the
ENTER key to be pressed after a channel
is selected, press the ENTER key to
select the channel. Problems changing
channels.
TTTTTroubleshooting roubleshooting roubleshooting roubleshooting roubleshooting
As a safety feature on SUR-35, you
must press the REC key for 3 seconds.
CCCCC
Won’t go into SETUP
mode Batteries are low. Replace batteries.
TTTTTable of Contents able of Contents able of Contents able of Contents able of Contents
Page
iii
Backlight doesn’t
work Backlight disabled. See Backlight
Time Period (pg. 53)