Sima Products Sima SUR-35 - Manual (Page 4)

SUR-35 User Manual
Ch.
SUR-35 User Manual
Ch.
Page
57
Appendix C – Troubleshooting
Pr Pr Pr Pr Prob ob ob ob oblem lem lem lem lem Solution Solution Solution Solution Solution
Batteries may be dead. Replace the batteries
with new Alkaline Batteries.
Check that the batteries are properly installed.
Make sure switch in battery compartment is set
to “NORM”
Make sure that the desired device screen on
the SUR-35 LCD panel has been selected.
Move closer to the device. The maximum
operating distance is approximately 30 feet.
Ensure that you are aiming the SUR-35 directly
at the device and that there are no obstructions
between the SUR-35 and the device.
Ensure programming with the learning function
or using the manufacturer codes has been
properly done.
If “error” message, try re-teaching button.
Make sure that you have correctly “taught” your
device’s remote control to the SUR-35.
Delete the device data from the SUR-35 and
carry out the learning function again.
Make sure you did not program more
than one remote for a given device.
The SUR-35
doesn’t operate a
device.
TTTTTroubleshooting roubleshooting roubleshooting roubleshooting roubleshooting
CCCCC
LCD does not
show anything
when you touch it
or press the
rubber buttons.
You cannot
operate a device
even after
teaching the
device using the
learning function.
“Full” message
appears. Device button capacity is full. Delete
a device.
TTTTTable of Contents able of Contents able of Contents able of Contents able of Contents
Page
iv
Collecting Unrecognized Infrared Codes.................. 31
Deleting a Specific Key ............................................... 32
Deleting a Device ......................................................... 33
Chapter 4 – Controlling Devices ..................... 35
Changing Touch Screen Pages ................................... 35
Selecting a Device to Control ..................................... 35
Controlling the Device ................................................ 36
Chapter 5 – Creating and Using Macros ....... 37
Introduction to Macros............................................... 37
Creating a Macro Sequence ......................................................... 37
Using Macros ............................................................................... 42
Deleting a Macro .......................................................................... 42
Chapter 6 – Other Features ............................. 43
Using Timers................................................................ 43
Setting Up a New Timer ............................................................... 44
Using Quick Channel Lists......................................... 46
Setting up Channel Lists .............................................................. 46
Deleting Channels from a Quick Channel List ............................ 48
Using Quick Channel Lists .......................................................... 49
Transmitting System Setup ........................................ 49
Using Sleep Mode ........................................................ 50
Displaying Version Number ....................................... 51
Chapter 7 – Changing SUR-35 Parameters ... 52
Power Down Time Period........................................... 52
Backlight Time Period ................................................ 53
Resetting to Factory Defaults ..................................... 54
Beep Toggling .............................................................. 54
Appendix A – Specifications ............................ 55
Appendix B – Accessories ................................ 56
Appendix C – Troubleshooting .................... 57
Warranty ....................................................... 60