Sharp PG-D40W3D - Manual (Page 31)

27
Basic
Operation
Image Projection
Adjusting the Projected Image
1 Adjusting the Focus
You can adjust the focus with the focus
ring on the projector.
Rotate the focus ring to adjust the
focus while watching the projected
image.
2 Adjusting the Height
The height of the projector can be
adjusted using the adjustment feet.
When the screen is above the projector,
the projection image can be made higher
by adjusting the projector.
1
Lift the projector to adjust its
height while lifting the HEIGHT
ADJUST lever.
2
Remove your hands from the
HEIGHT ADJUST lever of the
projector after its height has
been fi nely adjusted.
The angle of projection is adjustable up to
9 degrees from the surface on which the
projector is placed.
When adjusting the height of the projector,
trapezoidal distortion occurs. Follow the
procedures in Keystone Correction to correct
the distortion. (See pages
28 and 43 .)
•
Note
3 Adjusting the Picture Size
You can adjust the picture size using the
zoom ring on the projector.
Rotate the zoom ring to enlarge or
shrink the picture size.
•
Focus ring
Zoom ring
Focus ring
Zoom ring
HEIGHT ADJUST
lever HEIGHT ADJUST
lever
1
2
Make small
adjustments. Make small
adjustments.
Info
Do not apply too much pressure on the
projector when the front adjustment feet
come out.
When lowering the projector, be careful not to
get your fi ngers caught in the area between
the adjustment feet and the projector.
Hold the projector fi rmly while lifting or carrying.
Do not hold by the lens area. •
•
•
•