Swann 16-8500AI SW243-X6G - Manual (Page 20)

‰ Setting to the motion alarm
‰ Setting to the ETC (Alarm Input method, RS-232).
Go to SETUP menu(6.TECHNICAL SETTING - MOTION ALARM OUTPUT) to do setting the motion
alarm.
Go to SETUP menu(6.TECHNICAL SETTING - ETC.) to do setting the alarm and RS-232 device.
Alarm(sensor) input method can be set either NO(NORMAL
OPEN) or NC(NORMAL CLOSE) in each channel.
NO(NORMAL OPEN) sensor method normally keeps “OFF”
state and converts to “ON” state when sensor is detected.
NC(NORMAL CLOSE) sensor method normally keeps “ON”
state and converts to “OFF” when sensor is detected.
Alarm output method can be set by High Low or
Low High in each channel.
High Low method converts output circuit from
ON state
to OFF.
Low High method converts output circuit from
OFF state
to ON.
For more information related to RS-232 setting, see its
manufacture’s manual.
When motion is detected in each camera channel during
active time, alarm output device operates for alarm
duration time.
For motion alarm output setting, see “6. TECHNICAL
SETTING - MOTION ALARM OUTPUT”
Select MOTION ALARM-ENABLE in each camera
channel to use alarm output function and set alarm output
channel, duration and active schedule.
OPERA
TION