Alarm input, Motion alarm output – Swann 16-8500AI SW243-X6G User Manual
Page 38
z
RECORDING
CH / QUALITY
Select recording Channel (1~16 Ch) and record-
ing image QUALITY.
(Normal → Good → Better → Best → No Rec).
z
MESSAGE
Type TEXT to show on screen at alarm action
using screen keyboard (Max 15 characters).
z
OUT
Select alarm OUT channel (Alarm out 1~16).
z
DURATION
Select alarm DURATION time (5 → 10 sec).
z
ACTIVE TIME
Set alarm operating time.(Active time
window will be appeared.)
z
MAIN CH
Select Channel to display by full screen at alarm
action (1~16 Ch).
z
MOTION ALARM Select using MOTION detect function or not.
z
OUT
Select alarm OUT channel (Alarm out 1~16).
z
DURATION
Select alarm DURATION time (5 → 10 sec).
z
ACTIVE TIME
Set alarm operating time.(Active time
window will be appeared.)
Press + buttons on remote controller to select ALARM INPUT in SETUP menu.
ALARM INPUT
Press + buttons on remote controller to select MOTION ALARM OUTPUT in SETUP menu.
MOTION ALARM OUTPUT
SE
TUP
z
BUTTON BEEP
Select whether to make a beep when
you press the button on the remote
controller.
z
DVR ID
Enable “ID CONTROL” function to
control the selected one by using DVR
ID when several DVRs are installed in
the same place.
z
ID CONTROL
Select a number of DVR ID.
Press + buttons on remote controller to select REMOTE CONTROLLER in SETUP menu.
REMOTE CONTROLLER
If several DVRs are installed, you can control DVRs totally or selectively using one
remote controller. If the DVR has the same DVR ID, it will be controlled simultane-
ously. If you want to control a specific DVR, check the ID CONTROL and select
one DVR ID on DVR ID tab.