Sennheiser W300 IEM - Manual (Page 16)

14
The antenna mounts consist of:
y 2 BNC extension cables (screw-in BNC socket to BNC connector )
y 2 washers
y 2 nuts
y 2 antenna holders (GA 3030 AM only)
y 4 screws (GA 3030 AM only)
To front mount the antenna of the SR 300 IEM G2 transmitter :
̈ Screw the BNC socket of the BNC extension cables to the blanking plate
ƽ
using the supplied washer and nut.
̈
Connect the BNC connector to the BNC socket
ƺ
on the transmitter.
̈
Slide the transmitter into the 19’’ rack.
̈
Secure the rack mount “ears” to the rack.
̈ Connect the telescopic antenna to the BNC socket .
̈ Pull the end cap to extend the telescopic antenna .
To front mount the antennas of the SR 350 IEM G2 twin transmitter :
̈
Unsecure the rack mount “ears”
³
from the rack.
̈
Guide the BNC cables through the holes in the rack mount “ears” as shown
in the diagram on the left.
̈
Screw the antenna holders to the BNC sockets using the supplied
washers and nuts.
̈
Secure the antenna holders to the handles of the twin transmitter using
two of the supplied screws respectively.
ƽ
³
ew300_350_IEM_INT.book Seite 14 Freitag, 7. März 2008 8:55 08