Sennheiser W300 IEM - Manual (Page 17)

15
̈
Connect the two BNC connectors to the BNC sockets
ƺ
on the twin
transmitter.
̈ Slide the twin transmitter into the 19’’ rack.
̈ Resecure the rack mount “ears” ³ to the rack ³ .
̈
Connect the telescopic antennas to the BNC sockets .
̈
Pull the end caps to extend the telescopic antennas .
Changing the transmission power (SR 350 IEM G2 only)
With the SR 350 IEM G2 twin transmitter, you can choose between two
different transmission powers.
̈ Set the transmission power switch (RF POWER) ƻ to the desired position.
Transmission power will change as follows:
ATTENTION! Danger of interference with other transmitters!
Depending on the selected transmission power and frequency,
you may have to apply for an approval from the respective
authority for a radio transmission licence, as you could interfere
with other transmitters. This approval will only be valid for the
approved transmission power. For detailed information, please
refer to the enclosed frequency data sheets and to the country-
specific frequency and transmission power overviews.
̈
Apply for an approval, should country-specific regulations
on frequency and/or transmission power usage require this.
ATTENTION! Danger of damage to the device!
Due to the high transmission power (100 mW) in the switch
position “STANDARD”, the optional AC 2 transmitter combiner
must not be used as this can cause damage to the devices.
̈ Use only the optional AC 3200 transmitter combiner (see
“Accessories and spare parts” on page 40).
ƻ
Switch position Transmission power
LOW 15 mW
STANDARD 100 mW
ew300_350_IEM_INT.book Seite 15 Freitag, 7. März 2008 8:55 08