Samsung BN68-01736B-00 - Manual (Page 72)

English - 0
Setting Up Anynet+
1. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Application”, then press the ENTER
button.
2. Press the ▲ or ▼ button to select “Anynet+(HDMI-CEC)”, then press the
ENTER button.
3. Select the required option by pressing the ▲ or ▼ button, then press the
ENTER button.
4. When you are satisfied with your setting, press the ENTER button.
5. Press the EXIT button to exit.
Anynet+(HDMI-CEC)
To use the Anynet+ Function, “Anynet+(HDMI-CEC)”must be set to On.
When the “Anynet+ (HDMI-CEC)”function is disabled, all the Anynet+ related
operations are deactivated.
Auto Turn Off
Setting an Anynet+ Device to turn Off Automatically when the TV is Turned Off.
The active source on the TV remote must be set to TV to use the Anynet+
function.
If you set “Auto Turn Off” to “Yes”, connected external devices are also turned
off when the TV is turned off. If an external device is still recording, it may or
may not turn off.
➣
➣
➣
Scanning and Switching between Anynet+ Devices
1. Press the TOOLS button. Press the ENTER button to select “Anynet+
(HDMI-CEC)”.
2. Press the ▲ or ▼ button to select “Device List”, then press the ENTER
button
Anynet+ devices connected to the TV are listed. If you cannot find a
device you want, press the red button to scan for devices.
Only when you set “Anynet+ (HDMI-CEC)” to On in the “Setup” menu,
the “Device List” menu appears.
3. Press the ▲ or ▼ button to select to a particular device and press the
ENTER button. It is switched to the selected device.
Switching to the selected devices may take up to 2 minutes. You cannot cancel the operation during the switching
operation.
The time required to scan for devices is determined by the number of connected devices.
When the device scan is complete, the number of devices found are not displayed.
Although the TV automatically searches the device list when the TV is turned on via the power button, devices
connected to the TV when the TV is on or under some conditions are not automatically displayed in the device list.
Press the red button to search for the connected device.
If you have selected external input mode by pressing the
SOURCE button, you cannot use the Anynet+ function. Make
sure to switch to an Anynet+ device by using the “Device List”.
➣
➣
➣
➣
➣
➣
➣
Application
WISELINK
Anynet+ (HDMI-CEC) ►
Device List
Setup
U Move E Enter R Return
View TV
Device List
Recording
: DVDR
DVDR Operation
Receiver
: On
Setup
U Move E Enter R Return
Anynet+ (HDMI-CEC) : Off
Auto Turn Off
: Yes
U Move E Enter R Return
Setup
BN68-01736B-00Eng.indb 70 2008-09-01 �� 6:16:04