Sentry Industries PT22 - Manual (Page 27)

Displaying infeed status
The Istat or Iload command displays the status of one or more infeed.
This display includes the infeed absolute and descriptive names and the Input Status and current Load
reported to the Sentry by the infeed.
To display status of one or more infeeds:
Type istat and press Enter, or
Type iload and press Enter.
Examples
The following command displays the infeed status:
Sentry: istat
Input Input Input Input
Feed ID Feed Name Status Load
.AA HQ_1_Infeed_A On 10.5 Amps
.AB HQ_1_Infeed_B On 5.5 Amps
.AC HQ_1_Infeed_C On 9.0 Amps
.AD HQ_1_Infeed_D On 0.5 Amps
Connecting to a serial device
The Connect command allows Pass-Thru serial connection to devices attached to one of the two
standard serial ports (Console, Modem) or a Pass-Thru port.
To connect to a serial device:
At the Sentry: prompt, type connect, followed by the serial port name and press Enter.
Examples
The follow command connects to the serial device connected to the Modem port:
Sentry: connect modem<Enter>
To disconnect from a serial device:
Type !*break and press Enter.
Displaying the status of the Environmental Monitor
The Envmon command displays the status of the integrated Environmental Monitor.
By default, only administrative user accounts are allowed access to the Envmon command. An
administrator may user the Set User Envmon command to enable and disable access for other user
accounts.
To display the status of the Environmental Monitor:
At the Sentry: prompt, type envmon and press Enter.
Example
The following command displays the status of the Environmental Monitor.
Sentry: envmon<Enter>
Environmental Monitor .A
Name: Florida_HQ_1 Status: Normal
Temperature/Humidity Sensors
ID Name Temperature Humidity
.A1 Temp_Humid_Sensor_A1 Not Found Not Found
.A2 T/H2_Florida_HQ_1 23.5 Deg. C 22 % RH
Starting a new session
The Login command activates the Username: prompt. The current session ends, allowing a user to log
in and start a new session under a different username.
To start a new session:
At the Sentry: prompt, type login and press Enter. The Username: prompt appears.
Sentry PT22 Operations • 27
Installation and Operations Manual