Sharp XG-P610X - Manual (Page 26)

-26
Controlling the Projector via LAN
Controlling the Projector
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 24-
27 of the projector’s operation manual.)
Complete the AC cord connection. (See page
28 of the projector’s operation manual.)
Note
• When connecting the projector to the LAN, use a
commercially available LAN cable (UTP cable,
Category 5, cross-over type). When connecting
the projector to a hub, use a straight-through cable.
1
Start Internet Explorer (version 5.0
or later) on the computer.
2
Enter “http://” followed by the
projector IP address set by the
procedure on page
25 followed
by “/” in “Address”, and then
press the “Enter” key.
• The factory default setting for the projector :
“DHCP Client” is “OFF” and IP address is
“192.168.150.2”. If you did not change the IP
address in “3. Setting up a Network Con-
nection for the Projector” (pages
24 , 25 ),
enter “http://192.168.150.2/”.
3
A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
After connecting the projector to your network, enter the projector IP address in “Address”
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.