Sony 4-130-031-11(3) - Manual (Page 58)

58 GB
6
Press V/v repeatedly to select
the setting you want, then
press .
• RF AUTO: Normally select this. The
system change “RF CHNG” to “RF
ON” or “RF OFF” automatically.
• RF ON: The system transmits sound by
searching the better channel for
transmitting.
• RF OFF: The system transmits sound by
fixing the channel for transmitting.
To exit the menu
Press AMP MENU.
Notes
• When the wireless transmitter is not inserted in the
S-AIR main unit, you cannot set “RF CHNG”.
• In most cases, you will not need to change this
setting.
• If “RF CHNG” is set to “RF OFF,” transmission
between the S-AIR main unit and S-AIR sub unit
can be performed using one of the following
channels.
– S-AIR ID A: equivalent channel for IEEE
802.11b/g channel 1
– S-AIR ID B: equivalent channel for IEEE
802.11b/g channel 6
– S-AIR ID C: equivalent channel for IEEE
802.11b/g channel 11
• The transmission may be improved by changing
the transmission channel (frequency) of the other
wireless system(s). For details, refer to the
operating instructions of the other wireless
system(s).
(For EZW-T100A wireless transceiver
only)
1
Press AMP MENU.
2
Press V/v repeatedly to select
“S-AIR”.
3
Press or b to enter the
menu.
4
Press V/v repeatedly until “RF
POWER” appears in the front
panel display, then press
or
b.
5
Press V/v to select the desired
setting.
• “HIGH”: Normally select this.
• “LOW”: The RF output power is
decreased.
6
Press .
The setting is made.
7
Press AMP MENU.
The receiver menu turns off.
Changing the RF output power