Spirit XR425 - Manual (Page 12)

XR 425
11
STEP 4: RELEASE LEVER ASSEMBLY
1. Remove the M6 Button Head Socket Screw holding the clamp of the seat adjustment Release
Lever (40) by using the Allen Wrench (115). Install the Release Lever (40) onto the Handle Bar
(6) just behind the hand pulse sensors. Install the lever at an angle that allows easy access for
use, then install and tighten the socket screw removed earlier.
2. Secure the Seat Fore/Aft Release Cable (59) on the Handle Bar (6) by using the 2pcs of Velcro
Tape.
3. Install the Pedals (116 L, 117 R) in the Cranks by using the 14/15mm Wrench (132). Remember
that the left pedal has a reverse thread and will be screwed into the crank in the opposite
rotation from normal threads. There is an stamped into the end of the threaded post of the
left pedal and an in the right. Make sure to tighten the pedals as much as you possibly can.
It may be necessary to re-tighten the pedals if you feel a thumping during pedaling the bike. A
clicking noise, or thumping, sound during pedaling is usually caused by the pedals being too
loose.
4. Install the Upper Computer Cable (44) into the connector in the back of the Console (19). Install
the console onto the mounting plate with the 4pcs of M5x12mm Phillips Head Screws (99) by
using the Phillips Head Screw Driver (114).
5. Install the Front Stabilizer Cover (32) and the Rear Stabilizer Cover (37) on the Main Frame
with the 4pcs of M5x12mm Phillips Head Screws (99).