Sangean RCR-2 - Manual (Page 17)

16
GB
Alarm level adjustment
With alarm level adjustment switch 5, you may select required alarm
signal level.
Note:
Alarm level adjustment works only for buzzer alarm.
Display backlight on/off
Key 4 provides you to select whether you require to illuminate
the display.
Time zone switch
Time Zone Switch [7] should be set to zone where clock/radio is to
be used.
Troubleshooting /RESET
If the radio fails to operate correctly or some digits on the display are
missing or incomplete, carry out the following procedures.
1. With the aid of a suitable implement (the end of a paper clip),
press the RESET button 6 for a few seconds, this will reset the
microprocessor, clock time and clear all the stations stored in
preset memory .