SIIG 04-0600A User Manual
Page 6
6
3.
Engage the key hole nut into the key hole slot.
4.
Put tension on the assembly by gently pulling back
on the speaker mount post while tightening the
5/8"-32 x 5/8" machine screw, see Figure 4 on page
5.
5.
The key hole nut will engage on the housing in the
key hole slot.
6.
If the post does not tighten securely against the
housing, it will be necessarry to use the M5 x 1/8"
plastic washer as a spacer under the head of the
5/8"-32 x 5/8" machine screw, see Figure 4 on page
5.
2/4 Hole Mounting
1.
Find the best mounting configuration that matches
your speaker enclosure. Four-hole mount patterns
can be accomodated by positioning the speaker
plate diagonally, see Figure 5 on the next page.
2.
Using the 1/4"-20 x 1/2" machine screws, install the
speaker plate and secure the speaker enclosure, see
Figure 5
on the next page.