SIIG 04-0600A - Manual (Page 9)

9
ST5.5 c 45 Self
Tapping Screw
Figure 7
3. Drill holes through the drywall and into the wood
stud using a 1/8" drill bit. These holes should be
drilled 1-7/8" deep, see Figure 7 above.
4. After the holes are drilled, mount the wall plate
using the self tapping screws.
Drywall Surfaces
1. Locate the best mounting location in the ceiling or
wall. Using the wall plate as a template, mark the
hole positions on the mounting surface. For in-wall
applications, position the mounting holes in a vertical
pattern, see Figure 8 on the next page.
2. Drill holes in the drywall using a 5/16" drill bit.
3. Once the holes are drilled, insert the alligator anchor
into the holes. Make sure the anchor is flush with
the wall and/or ceiling surface, see Figure 8 on the
next page.