Stamina Products RECUMBENT BIKE - Manual (Page 8)

ASSEMBLY INSTRUCTIONS
8
NOTE: Be careful not to damage the PULSE SENSOR WIRES(104) while doing assembly Step 8 and
Step 9.
STEP 7
Attach the SEAT FRAME(6) onto the SEAT SUPPORT TUBE(5) with NYLOCK NUTS(M8x1.25)(80).
STEP 8
Attach the HANDRAIL(7) onto the SEAT FRAME(6) with CARRIAGE BOLTS(M8x1.25x50mm)(99) and
NYLOCK NUTS(M8x1.25)(80). Run the PULSE SENSOR WIRES(104) through the upright of the SEAT
FRAME(6) and plug it into the socket on the REAR FRAME(2).
STEP 9
Attach the SEAT(36) to the SEAT FRAME(6) with HEX BOLTS(M8x1.25x15mm)(97). Attach the BACK
CUSHION(35) to the SEAT FRAME(6) with HEX BOLTS(M8x1.25x40mm)(96).