SmartBridges sB3210 - Manual (Page 38)

Page 38 of 55
airPoint™ Nexus User Configuration Guide
i n t e l l i g e n t w i r e l e s s p l a t f o r m
5.2.2 Load Operating Profile
To load the operating profile:
1. Select a profile to load from the Profile Table:
2. Click the Load Profile button to load the selected profile.
Note: Current configuration parameters will be replaced by the new loaded profile. User will be
asked to wait while the new profile loads.
5.2.3 Profile Calendar
Profile calendar allows user to manage profiles based on different calendar times. User can configure
different profiles and scheduled activities based on the different profiles at a pre-defined time.
A typical situation is an operator has two profiles, to be switched on alternatively during the day and
during the night time. User creates the two different profiles and save them as Profile Day and Profile
Night and use the Profile Calendar to schedule the activation of the two profiles.
Follow the steps below to schedule the activation of a saved profile:
1. Select a profile to schedule.
2. Uncheck the ‘Disable Profile Calendar’ check box. A profile calendar will be displayed
3. Select date, time from the load time calendar. Use the calendar icon to choose a start date.
4. Select the recurrence (daily, weekly, monthly, only once).
5. Click the ’Apply Changes’ button. The schedule will be loaded either daily, weekly monthly or
only once at the specified start date and time.
6. To disable the scheduled profile, check the check box ‘Disable Profile Calendar’.
Figure 5-6 Profile Calendar