Smeg DI614H - Manual (Page 19)

19
7.3 CHANGING THE PROGRAMME
To change a programme while it is running, proceed as follows:
• press button (F) to set the programme in pause status;
• open the door and select the new button using button (B);
• close the door; the changes relating to the new programme
will appear on the DISPLAY (G).
7.4 STOPPING A PROGRAMME
• To stop a programme while it is running, it must first be
interrupted by pressing button (F);
• then open the door and press button (B) in repetition until you
obtain “Annul cycle 0”;
• close the door. “Empty tank” will appear on the DISPLAY (G)
and the dishwasher will start to pump out the water. This will
be completed in about 1 minute and “Progr. End” will appear
on the top line of the display.
Before the door is closed, a long washing time will appear
alongside "Empty tank”. This is not a malfunction but simply
a stage in the time update process; the time will be corrected to
1 minute when the door is closed.
END OF PROGRAMME
At the end of the programme the buzzer sounds (if enabled), after
which the temperature and programme name will alternate with
“Progr. End” on the top line of the DISPLAY (G); the bottom line
continues to show “Duration XX min”.
REMOVING THE DISHES
At the end of the washing programme, wait at least 20 minutes
before removing the dishes, to allow them to cool. To ensure that
any drops of water left in the top basket cannot drip onto the dishes
still in the bottom basket, you are advised always to empty the
bottom basket first, followed by the top basket.
EN Instructions for the User