SUUNTO D6 User Manual
Page 43
In order to minimize the risk of error during a dive, it is highly recommended that the
mixes are set in the proper order. This means that as the mix number rises, so does
oxygen content, and this is the order they are usually used during the dive. Before a
dive, only set to “ON” the mixes you actually have available and remember to check
the set values to make sure they are correct.
The default oxygen percentage (O
2
%) setting is 21% (air) and oxygen partial pressure
(PO
2
) setting 1.4 bar. After entering values for MIX1, you can enable/disable and set
an additional gas mix - MIX2.
ADJUST WITH
UP AND DOWN
BUTTONS. ACCEPT
WITH SELECT
BUTTON.
ADJUST WITH
UP AND DOWN
BUTTONS. ACCEPT
WITH SELECT
BUTTON.
NOTE
If only MIX1 is enabled (MIX2 set OFF), MIX1 will revert to default
settings (21% O
2
and PO
2
1.4 bar) after approximately 2 hours.
If MIX2 is set ON, settings for all mixes are stored until changed.If
either MIX2 or MIX3 have an oxygen content of 22% or greater,
settings for all mixes are stored until changed.
43