Seiko Instruments G1216B1N000-3D0E - Manual (Page 17)

AN.No.G1216B1N000-3D0E
- 14 -
3. OPERATING INSTRUCTIONS
3.1 Terminal Functions
8 I/O MPU Common terminal for tristate input and output, and data bus.
Functions Destination I/O QTY Signal
DB
0
to DB
7
E 1
Enable
Write (R/W=0):Latches data of DB
0
to DB
7
at the fall of E.
Read (R/W=1):Outputs data to DB
0
to DB
7
while “E” keeps a
high level.
Input MPU
R/W 1 Input MPU
Read/Write selection
R/W=1: When E=1 and CS1=0 or CS2=0, the data is output
to DB
0
to DB
7
and read is available by MPU.
R/W=0: When CS1=0 or CS2=0, DB
0
to DB
7
are ready for
receiving the input.
D/I 1 Input MPU
Data/Instruction selection
D/I=1: Indicates that the data in DB
0
to DB
7
is the display
data.
D/I=0: Indicates that the data in DB
0
to DB
7
is the instruction
code.
CS1, CS2 2 Input MPU
Chip select input. Data input and output is possible under
the following status:
Terminal No.
Status
RST 1 Input MPU
Reset signal
Setting the RST signal to a low level allows for initial setup.
(1) ON /OFF register: 0 setup (display OFF)
(2) Display start line register: 0 line setup (display starts
from 0 line)
The setup status is retained until the status is changed by an
instruction after reset is released.
V
DD
1
Power Power terminal for logic (+5 V)
V
SS
1
Power GND terminal (0 V)
V
LC
1
Power Power terminal for LC drive
LEDA 1
Power LED backlight anode terminal
1 F GND terminal is connected to the metallic frame of the module. Use this terminal when
grounding the frame.
LEDC 1


Power LED backlight cathode terminal
F GND 1

Frame ground 1
CS2 CS1
LCM display screen
CS1
0
CS2
0
CS1: Controls the LCM left half display screen (SEG1 to
SEG64).
CS2: Controls the LCM right half display screen (SEG65 to
SEG128).
Table 1 Terminal Functions