Samsung SPD-1000 - Manual (Page 13)

25 24
1. First, connect one end of the BNC
video cable connector to the Video
Output Terminal.
2. Next, connect the other end of the
connector to the Video Input Terminal
of the monitor.
for
3. Connect the Controller Connection Terminal
of SPD-1000 and the external
Controller.
4. Then, connect the Power Adapter Cable. Use a driver (-) to screw one part of
the Power Adapter consisting of two lines to the Power Input Terminal of
the camera holder.
5. Connect the Power
Adapter’s plug to the Power
Outlet.
Installation
Cable Connection Installation of SPD-1000
Video Out
Terminal Monitor
In Terminal
Monitor
Controller Connection
Terminal
DATA BOX
Controller
Power Adapter
• Precautions for Installation
- Check that the installation location can safely bear four times the weight of
the camera and its installation fittings.
- When fixing the ceiling installation bracket, use the supplied installation
template and fixing screws.
- Take care not to drop the product during installation. Do not allow anyone to
stand below the installation area.
• Optional Products for Installation
1) Wall Mount (STB-280PW)
This housing is used to install the camera on an indoor wall or ceiling using an
external conduit.
2) Wall Mount(STB-230PW)
This housing is used to install the camera on an indoor wall
4) Dome Housing (STH-1000PI)
This housing is used to install the camera in a location
that is dusty, or a place where extra protection for the
camera is required.