Samsung Msys SF-830 - Manual (Page 68)

S ENDING A F AX 4.7
4
Confirming Transmission
When the last page of your document has been sent
successfully, the product beeps and returns to Standby mode.
If something went wrong during your fax transmission, an error
message appears on the LCD display. For a listing of error
messages and their meanings, see page 10.13. If you receive an
error message, press Stop/Clear to clear the message and try
to send the document again.
You can set your product to print out a confirmation report
automatically each time sending is completed. For details, see
“Message Confirmation” on page 8.2.
Using Toll Save Transmission
If you have set a specific toll save time, you can quickly set your
document(s) to be sent at the preset time using the SAVE Toll
button on the front panel. Using this feature, you can take
advantage of lower long distance rates at night, for example.
The toll save end time is fixed to midnight (12:00 PM). Therefore
the toll save time slot is determined by the start time you
specify. If you have set 9:00 PM for the start time, the document
you set to use the toll save feature will be transmitted during the
toll save time slot (9:00PM-12:00PM).
To set the Toll save start time:
1 Press and hold the SAVE Toll button on the control panel.
The LCD display prompts you to enter the time.
2 Enter the specific start time using the number keypad, then
press Enter to save the setting.
To send a fax using the Toll save feature:
1 Press SAVE Toll on the control panel briefly. “ON” or “OFF”
appears on the bottom line.
2 To activate the toll save feature, select “ON” by using the
SAVE Toll button or the navigation buttons.