Smart Technologies Smart Document Camera 330 - Manual (Page 3)

Important information
WARNING
–
Failure to follow the installation instructions shipped with your SMART product
can result in personal injury and damage to the product.
– Ensure that any cables extending across the floor to your SMART product are
properly bundled and marked to avoid a trip hazard.
– Do not push foreign objects into the openings on your document camera.
– Do not open or disassemble your SMART product. You risk electrical shock
from high voltage. Opening the casing also voids your warranty.
– The camera arm on your SMART product has joints that present a pinch
hazard when you move the camera arm. Keep clear of the pinch points.
– Do not stare into the lamp or shine the lamp directly into someone’s eyes.
Turn off the lamp when displaying or capturing images of people.
– Do not overload power outlets or extension cords as this can result in a fire or
electric shock.
– Turn off and disconnect your SMART product before a thunderstorm. During a
thunderstorm, do not touch your SMART product or the power plug because
there is a risk of electrical shock.
– To reduce the risk of fire or electric shock, do not expose your SMART
product to rain or moisture.
CAUTION
–
Place your SMART product on a solid surface to prevent it from falling.
– If you have a security cable attached to your SMART product, do not carry or
swing your SMART product by the security cable.
– Do not connect non-shielded interface cables to your SMART product and do
not leave cables connected to unused connectors because this can cause
interference levels that exceed FCC regulations.
– Do not set up and use your SMART product in an area with excessive levels
of dust, humidity or smoke or near heat sources.
– Do not block or cover the openings or slots on your SMART product. These
slots provide ventilation, ensure reliable operation and protect your SMART
product from overheating.