Sherwood DD-6200 - Manual (Page 12)

1 2
RECORDING
Be sure the erase-protection taps on the tape are in
place.
The type of tape(normal or chrome) is automatically
detected.
The metal tapes are not recorded correctely.
To restart recording, press the corresponding PLAY
button.
According as there are the erase-protection taps or
not, the PLAY indicators are flickering as follows ;
When selecting recording of both sides and recording
first on the back side, recording is made only on that
side.
: Recording of a single side.
: Recording of both side. ,
: Recordable on both sides.
: Recordable on front side.
: Recordable on back side.
The unit will make a 4 second blank space and then
enter the recording pause mode.
Load a tape to be recorded into deck A.
1
Select the reverse mode.
2
When recording with Dolby B NR, select
the Dolby B NR mode.
3
Select the program source to be recorded.
Example) When selecting the tuner.
4
Press the RECORD/RECORD MUTE
button to enter the recording pause mode
5
Press the PLAY button to start recording.
6
To temporarily stop recording.
7
To make a blank space, press the
RECORD/RECORD MUTE button in
the recording pause mode or during
recording.
8
REVERSE
NR B/OFF