Sherwood DD-6200 - Manual (Page 14)

1 4
COUNTER DISPLAY
Select the corresponding tape length according to the
loaded tape in the time counter mode.
Example) When selecting the 60 minutes as tape
length.
Each time this button is pressed, the tape
length changes as follows ;
During playing or recording, the elapsed playing or
recording time is displayed.
The time counter is not actually a clock, so the
displayed time is not exactly equal to the actual
elapsed time.
Selecting a counter mode Selecting a tape length
DUBBING FROM DECK B TO DECK A
For better sound quality, select the normal speed
dubbing mode.
During dubbing, the tape is recorded in accordance
with the recording condition of the tape to be played
regardless of the Dolby NR mode. Because dubbing starts from the front side, if there is
not the erase - protection tap on that side, dubbing
can not be performed.
During dubbing, only the STOP button of the deck function buttons does work.
There are two kinds of counter mode : tape counter,
time counter for displaying the elapsed playing or
recording time.
Select the desired counter mode.
Each time this button is pressed, the counter mode
changes as follows ;
Open the cassette door by pressing the
EJECT button and load a blank tape into
Deck A and prerecorded tape into Deck
B respectively.
1
To stop dubbing.
3
Start dubbing.
2
NORMAL : Normal speed
dubbing.
HIGH : 1.5 times as fast as
normal speed dubbing.
: Tape counter mode
: Time counter mode
C-60 C-90 C 120
DUBBING
NORMAL HIGH
MODE
TAPE SIZE