Samsung DynaFlat TX R3075WH - Manual (Page 31)

English - 31
O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air”
(antenna) and cable channels. After the available channels are memorized, use the
CH and CH buttons to scan through the channels. This eliminates the need
to change channels by entering the channel digits. There are three steps for
memorizing channels: selecting a broadcast source, memorizing the channels
(automatic) and adding/deleting channels (manual).
Selecting the Video Signal-source
Before your TV can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button.
Press the … or † button
to select “Channel”, then
press the ENTER button.
2
Press the ENTER button to
select “Antenna”.
Press the … or † button to
select “Air” or “Cable”, then
press the ENTER button.
3
Press the … or † button
to select “Auto Program”,
then press the ENTER
button. Antenna : Air √
Auto Program √
Add/Delete √
Favorite Channels √
Name √
Fine Tune √
Signal Strength √
T V Channel
Antenna : Air √
Auto Program √
Add/Delete √
Favorite Channels √
Name √
Fine Tune √
Signal Strength √
T V Channel
Antenna : Air
Auto Program
Add/Delete
Favorite Channels
Name
Fine Tune
Signal Strength
T V Channel
Air
Cable
Alternate method:
Press the AUTO. PROG
button on the remote
control to select the Auto
Program.
Select the antenna connection
ANT A ANT B
T V Auto Program
Air None
Cable None
Air Cable
Cable Air
AA68-03263C-00_eng_Chapter3 3/11/05 4:36 PM Page 31