Sony TA-VA8ES - Manual (Page 18)

Using Surround Sound
18 EN
3
Rotate the BASS/TREBLE digital processing
control knob to select “BASS” or “TREBLE”.
4
Use the TONE LEVEL digital processing control
knob to raise or lower the level.
5 Repeat steps 3 and 4 as necessary to obtain the
tone you desire.
You can turn off the tone adjustments without
erasing them
Press EQ/TONE ON/OFF on the remote to turn the
tone parameter off or on. The tone adjustments and on/
off setting are stored in each sound field.
Adjusting surround sound parameters
Change the surround parameters to fit your listening
situation. Refer to the chart on the next page for
parameters you can adjust in each sound field.
To adjust the parameters of the PRO LOGIC sound
field, see “Getting the Most Out of Dolby Pro Logic
Surround Sound” on page 15.
1
Press DPC MODE repeatedly until the
SURROUND indicator lights up.
2
Use the PARAMETER digital processing control
knob to select the parameter you want.
3 Use the LEVEL digital processing control knob to
adjust the level of the parameter.
The adjusted parameters are stored automatically.
Note
If you make new adjustments to a sound field, the
previous settings are replaced by the new ones.
Resetting customized sound fields to the
factory settings
1
If the power is on, press POWER to turn off the
power.
2
Hold down SOUND FIELD ON/OFF and press
POWER.
“SURR CLEAR!” appears in the display and all
the sound fields are reset at once.