Sony IPELA NSR-100 - Manual (Page 127)

127
Chapter 5 Settings
Detection areas cannot be deleted.
Caution
• The VMD (Camera) setting cannot be configured when the mount angle
is set to 90 or 270 degrees.
• The VMD (Camera) setting is only active when the codec setting is
MPEG.
Sleep time after detection (sec)
Enter a duration from 1 to 30 seconds to pause motion detection after
motion has been detected.
Area1 to Area4
Select the check boxes of the detection areas to enable.
Threshold
Enter a value from 1 to 2,000 as the threshold for motion detection.
The motion detection processor uses this value as the standard value for
determining whether motion has occurred between two video frames.
Sensitivity
Enter a value from 0 to 20 as the sensitivity level.
Normally, you do not need to configure this setting.
x For the SNC-V704 and similar cameras
You can set up to two motion detection areas. The name of the area being
configured is displayed in blue.
Drag the red frame with your mouse to configure a motion detection area.
By dragging each edge of the detection area, you can change its size.
Detection areas cannot be deleted.