Sony IPELA NSR-100 - Manual (Page 29)

29
Chapter 2 Initial Configuring the System
13
Configure each item, and then click [Accept].
Configure the settings depending on your network.
When using a DHCP server to configure address settings
automatically
Select [DHCP].
When wanting to configure addresses manually
(1) Select [Static].
(2) Enter the following information.
IP Address
Enter the desired IP address.
Notes
• Before you enter the desired IP address, make sure that it is not already
used on the network. Entering an IP address already in use may lead to
erratic operation of the unit, but no error messages appear to indicate
the fact.
• Because of IP address attribution rules, setting invalid addresses such
as the ones below are not allowed.
Example: 224.0.0.0 to 255.255.255.255
0.0.0.0
127.0.0.1, etc.
Netmask
Enter the subnet mask address.
Note
The default settings for network devices are as follows.
IP Address:192.168.[0/1/2]*.1
Netmask: 255.255.255.0
* The settings for each of the network devices #1, #2, and #3 (only network
device #1 for the NSR-25).