Sony IPELA NSR-100 - Manual (Page 124)

124
Chapter 5 Settings
Name
Enter the sensor input name in this text box.
Invert
Select this check box when you want to invert the pulse polarity (for
example, when you want to invert high
t low to low t high).
Enable
Select this check box when you want to enable the sensor input.
3
Once you have configured all the desired settings, click [Save] in the upper-
right corner of the window.
The settings are applied.
If you want to ignore all your setting modifications, click [Discard].
Setting a Video Motion Detection (Camera) Pin
To use the camera-based motion detection and object detection functions (Video
Motion Detection (Camera)), follow the steps below to configure a Video
Motion Detection (Camera) pin and a motion detection or object detection area.
The settings available for motion detection and object detection areas will differ
depending on your camera.
Notes
• Whether Video Motion Detection (Camera) supports both motion detection
and object detection differs depending on the camera.
• Video Motion Detection (Camera) cannot be used with the SNT-V304 and the
SNT-V501.
Caution
• With NSR, metadata transmission from a camera cannot be used in tandem
with the Video Motion Detection (Camera) setting on that camera. If the
Video Motion Detection (Camera) setting is enabled, the Video Motion Filter
setting of the camera will be disabled.
• Object detection requires an approximately 40 second initialization period
before starting.
1
Click [Sensor Input] in the tree on the left side of the window.
2
Select the camera below [Sensor Input], and click the Video Motion
Detection (Camera) pin you want to configure.
The “Sensor Input” screen appears.