Sega Satellite TV System - Manual (Page 3)

34 www.seuservice.com
www.seuservice.com
35
Place all the adjusters against the floor. Use a wrench to adjust the height of the adjusters so that
the satellite is horizontally level.
Following adjustment, tighten the nut on each adjuster to fix the height.
Replace the 4 covers at the corners.
PHOTO 6. 2 b
Be sure to make contact with the surface.
Fasten upward.
Follow the procedure below to attach the instruction plate and the instruction holder to the
service door.
Exercise caution, as the service door closes by its own weight, and can injure hands or fingers.
Do not over-tighten the flange nuts, as this could damage the instruction plate.
Release and open the service door.
Secure the instruction plate to the service
door using 6 carriage bolts and flange/cap
nuts. Push the carriage bolts all the way
through the holes, and tighten the 4 flange
nuts from the inner side of the service door
and the 2 cap nuts in the upside.
FIG. 6. 2 c
CARRIAGE BOLT (6)
M4×10, chrome plated
FLANGE NUT (4)
M4
INSTRUCTION PLATE
SERVICE DOOR
Release
FIG 6. 2 b
Refer to this figure (scale: 1/100) for
the layout of the place of installation.
INSTRUCTION HOLDER
CAP NUT (2)
M4, flat washer used
3
4
7
6
5
8