Sony HT-AF5 - Manual (Page 29)

29 GB
Getting Star
ted
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2
Press V/v repeatedly to select
the item, then press .
Note
After “SAVE EXIT” is displayed for 50
seconds, the measurement result is saved
automatically, without the need to save the
procedure.
3
Save the measurement result.
Select “SAVE EXIT” in step 2.
The measurement results are saved.
When error codes appear
Try the remedies and perform the Auto
Calibration again.
When you select “WRN CHECK”
If a warning on the measurement result is
present, detailed information is displayed.
Press or B to return to step 2 of
“Confirming/saving the
measurement results”.
Confirming/saving the
measurement results
Measurement
result Display Explanation
When the
measurement
process
completes
properly SAVE
EXIT Proceed to
step 2.
When the
measurement
process fails ERROR
XXXX
See “When
error codes
appear” (page
29).
Item Explanation
SAVE EXIT Saves the measurement
results and exits the setting
process.
WRN CHECK Displays warning
concerning the
measurement results. See
“When you select “WRN
CHECK”” (page 29).
DIST INFO Displays the measurement
result for speaker distance.
LEVEL INFO Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
Error code Cause and remedies
ERROR 32 • The sound received by the
optimizer microphone is out of
the acceptable range.
• The optimizer microphone or
subwoofer may be damaged.
Contact your Sony dealer or local
authorized Sony service facility.
ERROR F 33 The front speakers are not
connected or either the front left or
front right speaker is not
connected.
Check that the front speakers are
connected properly.
ERROR SR33 Either the surround left or
surround right speaker is not
connected.
Check that the surround speakers
are connected properly.
ERROR SW33 The subwoofer is not connected or
it may be damaged.
Contact your Sony dealer or local
authorized Sony service facility.
Warning code Explanation
WARNING 40 The Auto Calibration has
completed. However, the noise
level is high. You may be able to
perform the Auto Calibration
properly if you try it again, even
though the measurement cannot
be performed in all environments.
Try to perform the Auto
Calibration in a quiet
environment.
continued