Samsung WM1255A - Manual (Page 14)

12 SAMSUNG Washing Machine Owner’s Instructions
Washing a Load of Laundry
Using Dry course
Refer to the label of drying capacity and be sure to put in the clothes to the lower level than
the marked line for the dried clothe of 6.0kg.
1. Open the door, put in the clothes and close the door again.
2. Press the POWER button and then press the Drying Selector button.
: The standard course will be selected automatically.
Drying is availably selected only at the courses such as Towel, Cotton, Cotton 95 ˚C,
Cotton 75 ˚C, Coloureds and Quick.
3. Select Drying Selector button as follows.
: Every press of this button will select drying type repeatedly in the following order:
Standard ( ) → Sterilization ( ) → Easy Iron ( ) → Low Temperature ( ) →
Time Setting ( ) (30 min → 60 min → 90 min → 120 min → 150 min) →
Standard ( )
• It automatically displays Drying Time by sensing the weight of clothes before drying
for increasing the drying effect.
4. Put suitable amount of detergent and fiber softener in the detergent tray and close it
again.
5. Press Start/Pause button.
: It automatically performs an optimal function from washing to drying.
Remark:
• The selected course can’t be altered after the start of drying.
• If you select Drying function, the intensity of SPIN will be set up as 1000rpm in default
for increasing the drying effect.
• If cold water is not supplied, drying will not be performed.
• If you do not take out clothes from the tub after the end of drying, a function of
wrinkle protection will be performed for about 3 minutes with the display of [End].
In order to take out the clothes: press firstly PAUSE or POWER button and take them
out.
• In case you wish to dry after hand washing, select both SPIN and Drying at the same
time.
WM1255A-02255B-GB-1026.indd 12 2005-10-26 ¿АИД 5:51:52