Connecting the water supply hose, Drain hose connection procedures, Positioning the drain hose – Samsung WM1255A User Manual

Page 7: Installing the washing machine

Advertising
background image

SAMSUNG Washing Machine Owner’s Instructions 5

Installing the Washing Machine

Connecting the water supply hose

1. Remove the adaptor from the

water supply hose.

c

4. Connect the water supply hose to

the adaptor. Pull down part (c) of

the water supply hose.

When you release part (c) the

hose automatically connects to the

adaptor making a 'click’ sound.

2. First, using a ‘+’ type screw driver,

loosen the four screws on the

adaptor. Next, take the adaptor

and turn part(b) following the

arrow until there is a 5mm gap.

5. Connect the other end of the water

supply hose to the inlet water

valve at the top of the washer.

Screw the hose clockwise all the

way in.

3. Connect adaptor to the water tap

by tightening the screws firmly.

Then, turn part (b) following the

arrow and put(a) and (b) together.

a

b

If the water tap has a screw type

faucet, connect the water supply

hose to the tap as shown.

NOTICE

After completing connection, if water leaks from the hose, then repeat the same steps. Use

the most conventional type of faucet for water supply. In case the faucet is square or too

big, remove the spacing ring before inserting the faucet into the adaptor.

Note:

The appliance is to be connected to the water mains using new hose-sets and that old

hose-sets should not be used.

Drain hose connection procedures

1. Holding down the handle of the drain hose

connector, put in the drain hose in desired

direction.

: Fix the hose into the drainage hole, and give

the hose connector a push to the body to fix

the hose.

Positioning the drain hose

The end of the drain hose may be positioned in three

ways:

Over the edge of a wash basin.

The drain hose must be placed at a height of

between 0 and 90 cm. To keep the drain hose spout

bent, use the supplied plastic hose guide. Secure

the guide to the wall with a hook or to the faucet

with a piece of string to prevent the drain hose from

moving.

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least

60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no longer than 90

cm.

WM1255A-02255B-GB-1026.indd 5

2005-10-26 ¿АИД 5:51:46

Advertising