Sony MSW-M2100 - Manual (Page 19)

Chapter 2
Location and Function of Parts
Chapter 2 Location and Function of Parts
2-11
ENTRY button
Use this for setting DMC playback control points and
so on.
• To set a speed variation start or end point: Hold down
the STUNT IN button or STUNT OUT button, and
press this button.
• To set an on-air start or end point: Hold down the
PLAY IN button or PLAY OUT button, and press
this button.
6 CUE/PLAY (cue up/playback) button
After setting an on-air start point (PLAY IN point) and
an on-air end point (PLAY OUT point), pressing this
button cues up the tape to the on-air start point. The
button then starts flashing to indicate that the unit is
ready for DMC playback operation. To start DMC
playback, press the button again.
7 LEARN button
After setting a speed variation start point (STUNT IN
point) and a speed variation end point (STUNT OUT
point), pressing this button makes the tape start
running. You can then use the search dial to vary the
tape speed, which is automatically stored in memory.
After thus storing the tape speed variation in memory,
pressing this button starts an automatic playback
between the speed variation start and end points at the
stored speed.
qs Shot mark section
1 LIST button
Use this button to read in and list shot marks.
2 REC/ERASE indicator
This lights in the state in which writing, amending, and
deleting of shot marks is enabled and flashes while a
shot mark is actually being written, amended or
deleted.
3 MARK button
Hold this button down for 2 seconds or more, to enable
writing, amending, and deleting of shot marks.
LIST GOOD SHOT MARK
REC/
ERASE
1 LIST button
3 MARK button
2 REC/ERASE indicator