Sony MSW-M2100 - Manual (Page 76)

Chapter 8
Setup Menus
8-6
Chapter 8 Setup Menus
Item number Item name Settings
a)The channel condition indication appears under the timer
or status line (under the video playback level indication
during playback of an analog tape), in the format “V
−A−”,
where the symbol following the “V” indicates the rotating
head condition for video channels and the symbol
following the “A” indicates the rotating head condition for
audio channels.
The following three symbols appear:
“
−” (good)
“*” (fair)
“x” (poor)
013
B01 RECALL BANK 1 Set to ON to recall menu settings from menu bank 1.
B02 RECALL BANK 2 Set to ON to recall menu settings from menu bank 2.
B03 RECALL BANK 3 Set to ON to recall menu settings from menu bank 3.
B11 SAVE BANK 1 Set to ON to save current active menu settings to menu bank 1.
B12 SAVE BANK 2 Set to ON to save current active menu settings to menu bank 2.
B13 SAVE BANK 3 Set to ON to save current active menu settings to menu bank 3.
B20 RESET SETUP Set this item to ON to return the current menu settings to the factory defaults.
Set it to bank-4 to use the contents of menu bank 4 as the current menu settings.
For details about menu bank 4, refer to the Maintenance Manual.
Item number Item name Settings
525/625 SYSTEM
SELECT
8-3 Items in the Basic Setup Menu
Specify whether to enable switching between 525-line (NTSC) and 625-line (PAL)
modes.
OFF : Do not enable system switching.
ON: Enable system switching.
Setting this item to ON and switching the system enables the unit to operate in
the system switched to.
For the switching between 525/625-line modes, see page 8-4.
Notes
• For the basic and extended setup menus, separate settings are saved for 525-
line (NTSC) and 625-line (PAL) modes. When you switch systems, all menu
items change to the settings established in the new system. (These are different
from the settings for the mode before switching.)
• When the MSW-M2100 is used in 625-line mode or when the MSW-M2100P is
used in 525-line mode, analog tape can only be played back in the simple
playback mode.
012 a) CONDITION DISPLAY
VIDEO MONITOR Specifies whether to add a channel condition indication to superimposed text,
when “x1” is selected in menu item 011.
DISABLE : Do not display.
ENABLE: Display.