Sony 1080i - Manual (Page 18)

18
Chapter 1 Overview
Chapter 1 Overview
Notes
• The command mode of the supplied Remote
commander is set to VTR4. You cannot change this
setting.
• Set [REMOTE CTRL] on the [OTHERS] menu to
[ON] to enable the Remote Commander to control the
unit.
• In addition to the Remote Commander supplied with
the unit, the unit accepts signals from any Sony
Remote Commander whose command mode is set to
VTR4. If you want to disable the control from any
Remote Commander, set [REMOTE CTRL] on the
[OTHERS] menu to [OFF].
Battery installation
1
Push and slide the lid to open.
2
Install two size AA (R6) batteries (supplied) with
the correct polarity.
3
Replace the lid.
Be sure to install the
battery from the
# side.
Notes on batteries
• Make sure that the battery orientation is correct when
inserting batteries.
• Do not mix an old battery with a new one, or mix
different types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If the batteries have leaked,
remove them, wipe the battery compartment dry and
replace the batteries with new ones.
To remove the batteries
Remove the lid as step 1 and take out the batteries.
Location and Function of Parts