Socket Mobile Series 7 - Manual (Page 19)

STEP 4: Scan Data into Your Application
1. Start the Windows application that you want to receive the data (e.g.,
Excel, Notepad, etc.). Make sure a document or spreadsheet is open.
2. Place the cursor where you want data from the next scan to go.
3. Press the trigger button and scan the code.
When data is read and sent to the mobile computing device, the laser will
turn off. Depending on your scanner settings, the scanner may beep
and/or the Hand scanner’s LED may flash green to indicate a good
read.
If no data is read in a few seconds, the laser will turn off, and you must
try again.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 19