Socket Mobile Series 7 - Manual (Page 29)

STEP 6: Scan Data into Your Application
1. Start the Palm application that you want to receive the data (e.g.,
Memo). Make sure a document or spreadsheet is open.
Note: You cannot scan data into Palm Note Pad, because it is a
graphics-based program.
2. Press the trigger button and scan the code.
When data is read and transmitted to the host, the laser will turn off.
Depending on the settings chosen in the SocketScan Configure screen,
the scanner may beep and/or the LED may flash green.
If the Scanner fails to read data within a few seconds, the laser will turn
off, and you must try again.
CHAPTER 3: SETUP FOR PALM 29