Sanyo PLC-WXU300K - Manual (Page 49)

4
Enter a Logo PIN code
Use the Point
▲▼ buttons to enter a number. Press the
Point ► button to fix the number and move the red frame
pointer to the next box. The number changes to “”. If
you fixed an incorrect number, use the Point ◄ button to
move the pointer to the number you want to correct, and
then enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the pointer to
Set
. Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect Logo PIN code, Logo PIN
code
and the number () will turn red for a
moment. Enter the correct Logo PIN code all over again.
Logo PIN code can be changed to your desired four-digit
number. Press the SELECT button to select Logo PIN
code change
. Logo PIN code dialog box appears, use
the Point ▲▼ buttons to enter the correct code. The New
Logo PIN code input dialog box appears. Set a new Logo
PIN code, confirmation box appears, choose yes to set
the new Logo PIN code.
Be sure to note the new Logo PIN code and keep it on
hand. If you lost the number, you could no longer change
the Logo PIN code setting.
Use the Point ▲▼ buttons to switch On or Off, and then
press the SELECT button to make a choice.
Change the Logo PIN code lock setting
Enter a Logo PIN code
CAUTION:
WHEN yOU HAVE CHANGED THE LOGO PIN CODE,
WRITE DOWN THE NEW PIN CODE IN COLUMN OF
THE LOGO PIN CODE NO . MEMO ON PAGE 80, AND
KEEP IT SECURELy . SHOULD THE LOGO PIN CODE
BE LOST OR FORGOTTEN, THE LOGO PIN CODE
SETTING CAN NO LONGER BE CHANGED .
Logo PIN code change
Setting
Cancel
Cancel
Logo PIN code change