Sanyo PLC-WXU300K - Manual (Page 50)

50
Ceiling
Rear
Ceiling
When this function is set to On, the picture will be top/
bottom and left/right reversed. This function is used to
project the image from a ceiling-mounted projector.
Rear
When this function is set to On, the picture will be left/right
reversed. This function is used to project the image from
rear of the screen.
Setting
HDMI setup
Picture in Picture
Standby mode Network
HDMI setup
This function is only used for HDMI input source.
Image
Normal: When the output of Digital R/G/B
equipment is set to Standard.
Enhanced: When the output of Digital R/G/B
equipment is set to Enhanced.
Sound
HDMI: When Digital input source is input,
Sound is set to HDMI.
Computer : When DVI input source is changed to
HDMI input source, Sound is set to
Computer .
The names for the output setting of Digital R/G/B vary
from equipment to equipment. For details, refer to the
owner’s manual of your Digital R/G/B equipment.
When the black parts of the image are destroyed or stand
out, please switch to Normal or Enhanced, and then switch
the output type of the HDMI Digital R/G/B output equipment.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back
of the projector is switchable for Computer 2 input or
monitor output. (See page 9)
Computer 
. . . Computer input
Monitor out
. . . Monitor out
Terminal function is not available when selecting Computer

to the input source. Change the input source to the others
(HDMI
or Computer 1 or Video) so that the Terminal
function will be available. (pp.27-28, 37-38)