Silicon Image SiliconDrive SSD-P16G(I)-3100 - Manual (Page 20)

E LECTRICAL S PECIFICATION SSD-P XXX (I)-3100 D ATA S HEET
S ILICON S YSTEMS P ROPRIETARY
This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc.
All unauthorized use and/or reproduction is prohibited.
3100P-06DSR P AGE 10 F EBRUARY 2, 2009
DMARQ
(True IDE mode) 43 O In true IDE mode, this signal is used
for DMA transfers between the host
and device. DMARQ is asserted by
the device when the device is ready to
transfer data to/from the host. The
direction of data transfer is controlled
by -IORD and -IOWR. This signal is
used in a handshake manner with
-DMACK (i.e., the device waits until
the host asserts -DMACK before
negating DMARQ, and reasserts
DMARQ if there is more data to
transfer). The DMARQ/-DMACK
handshake is used to provide flow
control during the transfer.
D15-D00
(PC Card memory
mode) 31, 30, 29,
28, 27, 49,
48, 47, 6,
5, 4, 3, 2,
23, 22, 21 I/O These lines carry the data,
commands, and status information
between the host and the controller.
• D00 is the LSB of the word’s even
byte.
• D08 is the LSB of the word’s odd
byte.
D15-D00
(PC Card I/O
mode) This signal is the same as the PC
Card Memory Mode signal.
D15-D00
(True IDE mode) In true IDE mode, all Task File
operations occur in byte mode on the
low-order bus D00-D07, while all data
transfers are 16 bits using D00-D15.
GND
(PC Card memory
mode) 1, 50 - Ground.
GND
(PC Card I/O
mode) This signal is the same for all modes.
GND
(True IDE mode) This signal is the same for all modes.
Table 8: Signal Descriptions (Continued)
Signal Name Pin Type Description