Symbol Technologies MC9000-G - Manual (Page 85)

Operating the MC9000-G 2-37
Image Capture Mode
In this default mode, upon pulling the trigger, the Imager attempts to locate and decode enabled bar
codes within its field of view. The Imager remains in this mode as long as the trigger is pulled, or until
a bar code is decoded.
Aiming the Imager
The imager version of the mobile computer projects a laser aiming pattern (shown below) similar to
those used on cameras. The aiming pattern is used to position the bar code or object within the field
of view.
Figure 2-16. Laser Aiming Pattern
Imager symbol scanning:
1. Center the symbol in any orientation within the aiming pattern. Ensure the entire symbol is
within the rectangular area formed by the brackets in the aiming pattern.
Figure 2-17. Centering Symbol in Aiming Pattern
Linear bar code PDF417 symbol
Symbol
View Finder
(Aiming Pattern)